g Replacing a Serial Cable ConnectionTransparent Mode |
| |
 In this mode, data from connected devices is transferred as is, without any changes. You can replace serial cables with Ethernet without changing communication software settings. Up to 254 units can be installed on the same line.
You can switch over to long-distance communication without changing the device setup or the software! |
g Add a COM port on your PC -Virtual COM Mode |
| |
 
In this mode, the unit is used as a COM port in a Windows® PC. Via Ethernet, you can operate a remote device as if it were right next to you. Access by socket communication is also supported.
< When using Windows 98/98SE/Me, up to four ports (COM 3 to 8) can be used at the same time. On Windows XP/2000, up to ten ports (numbers following existing ports) can be used at the same time.
Remote control via Ethernet is achieved by commands to COM ports! |
g N-to-N Packet Communication Using Dedicated Commands -Modem Mode |
| |
 This mode is used for creating communication programs and conducting packet communications using dedicated commands. You can conduct communications to multiple units (N-to-N) by appending packets with the device ID. 254 units can be installed on the same line. |