=====================================================================
=     CPS-MG341 Series Firmware Upgrade                             =
=                                CPS-MG341 Series firmware Ver1.0.6	       =
=                                                  CONTEC Co.,Ltd.  =
=====================================================================

◆ Table of Contents
=======
  Introduction
  Before upgrading
  Version upgrading procedure
  Version upgrading history


◆ Introduction
===========
  Thank you for your continued patronage of CONTEC products.

  This describes the additional information of CPS-MG341 series firmware upgrade.
  For how to use the product, please visit our website and see the system setup guide. 
  (http://www.contec.com)
 
◆ Firmware upgrading precaution
================================
*Do not downgrade the firmware.

◆ Before upgrading
===========
  Have the followings ready 
    ・Product (CPS-MG341 series)
    ・Host computer
    ・LAN cable
    ・Firmware upgrade file

◆ Version upgrading procedure
===========
  1.Turn on the power of the CPS-MG341 product.
  
  2.Connect the product to a host computer with a LAN cable.
  
  3.Access the product via web browser from the computer .
    
    If the CPS-MG341 still has the default setting, set the host computer on the same network 
    (e.g.:10.1.1.102) and enter "http://10.1.1.101 " in URL.
    
    If you are uncertain of your IP address, the default settings (10.1.1.101) can be 
    restored temporarily by turning on the power with SW1-2 switch on. 
        
  4.Log in the product.
    You will be asked to enter a user name and a password. Enter them and click "OK" button.
    
    If you are uncertain of the user name and/or password, the default settings (User name：mc341, 
    Password：mc341) can be restored temporarily by turning on the power with SW1-2 switch on. 
    
  5.Follow the instruction below to go to "Firmware version up" menu.
    In the "Status nemu", click "Maintenace menu", and then "Firmware version up"in the 
    Backup group.
    
  6.Upload the firmware upgrade file.
    Click "Browse" button. Specifiy the file in the host computer to upload.
    Click "upload" button.
    *If the firmware upgrade file is compressed (extension:zip), decompress it 
    before uploading（extension:bin).
    
  7.Upgrading will start and the product will be rebooted.
  
  8.After rebooting completes, check the version.
    Access the product via web browser again.
    From "Maintenance menu", click "System information" under the group of System.


◆ Version upgrading history
===========

Ver1.0.6f
  ・Modified Re-try at the time of communication error with PLC
  ・Changed to PLC data-stop from PLC data-save before synchronization.
  ・Changed the time-out value of Ethernet communication
  ・Fixed the display errors of device list.
  ・Modify the process upon re-transferring data to cloud.
  ・Fixed unsatisfactory communication with OMRON C series.

Ver1.0.0
--------------------------------
  Released the first edition.