FX5000系列
|
Ver.1.05 -> Ver.1.06
--------------------------------
・Added the following function
- Supports FXS5000-TW, FXA5020-TW for Taiwan, China
- Supports FXS5000-EU, FXA5020-TW for EU.
・Support for new models
- Added support for tagged VLAN functionality.
- Added AES fixed option for encryption settings in AP mode.
- Added 100 Mbps auto option for Ethernet port speed settings.
- Added dedicated features for models intended for specific companies.
・Problem fix
- Fixed an issue where, when using WEP/AES, the default key could become a fixed key with a higher index than the one specified in the default key setting.
- Fixed an issue where, during configuration file restore, the mesh link down sensing and controller backup target device IP address/password were not applied.
- Fixed an issue where, when link-down sensing was set to stop wireless, the 5 GHz wireless module might not start properly after link recovery (this did not occur on 2.4 GHz). Also fixed an issue where, when the condition was set to Ping and the post-link-down action was set to Restart, the link-down sensing function did not operate correctly.
- Fixed an issue where the link monitoring setting time was treated as cumulative disconnection time instead of continuous disconnection time (in seconds).
- Fixed an issue with LED control during log writing.
- Fixed an issue where, in station mode, if wireless connection attempts failed continuously, the device would stop trying to connect to that network (ESSID) for a while, causing reconnection delays.
- Fixed an issue where, in dual-station communication, different wireless interfaces could be used for transmit (uplink) and receive (downlink), resulting in different paths.
- Fixed an issue where channels 149–161 were missing from the scan channel list for KR models intended for Korea.
・Other
- Added note table and VAP information (channel, login status, supplicant status) to the private SNMP MIB.
- Supported in FXE5000 private MIB file version 1.02 and later.
- Changed behavior to output logs as paniclog when an unintended reboot occurs.
- Modified specification to compress log files for storage. Note: If firmware is rolled back to a version prior to this change, previously saved logs will be deleted due to specification differences.
- Changed behavior so that, when log saving is enabled, reference log file merging is no longer performed during Flash ROM save timing.
- Changed ST mode behavior to output the scan list instead of the login AP information when retrieving wireless node information via the F&eIT protocol.
- Adjusted debug logs.
- Updated help content.
|
下载 |