Ver. 1.06.00 → 1.10.00
----------------------------------------

*** Added the following function ***
• ・Added the "Automatic TX Power" feature.

*** Problem fixes ***
• ・Fixed an issue where an error page was displayed on Status > Wireless LAN in the Web configuration interface when more than 129 neighboring access points were detected.
• ・Fixed an issue where the aging time of wireless node information did not decrease from 300.
• ・Fixed an issue where the password could be changed via the Web configuration interface, but the completion screen was not displayed after a successful change.
• ・Fixed an issue where the timestamp was not displayed in the RSSI graph on Status > Wireless LAN in the Web configuration interface when operating in station mode, causing the graph to be misaligned.
• ・Fixed an issue where the channel, login status, and supplicant status of VAP6 were incorrectly reported as VAP7 in snmpd.
• ・Fixed an issue where log files could not be saved.
• ・Fixed an issue where some settings were not properly backed up or restored during configuration file backup and restore.
• ・Fixed an issue related to roaming notification packets.

*** Other ***
• ・Added support for JC-STAR Level 1 compliance and updated the security policy accordingly.
• ・Added Channel Utilization and Noise Floor graphs to Status > Wireless LAN in the Web configuration interface.
• ・Added channel utilization information for each VAP to Status > Wireless LAN in the Web configuration interface.
• ・Modified the F&eIT protocol to allow retrieval of Ethernet interface (eth0) information other than counters.
• ・Added an option to enable or disable EEE on the wired LAN interface.
• ・Added a monitoring function for CPU and memory usage that automatically reboots the device when a problem is detected.
• ・Added an Enable/Disable F&eIT Protocol setting under Advanced Settings > Device > Access Control.
• ・Modified the scan result display in the Web configuration interface so that the ESSID of access points with security enabled and the same ESSID as the local device is shown.
• ・Added a 30-second lockout interval after three or more consecutive password authentication failures when logging in via Web or FTP, preventing immediate retry.
• ・Added a 6% transmission power option.
• ・Added support for verification and writing of firmware images that include a digital signature.
• ・Modified the system so that roaming-related debug logs are not output while operating in station mode.