Cables and Accessories for 37-pin D-SUB Connector Type

This section guides you through the cables and accessories used with 37-pin D-SUB connector-type products and how to connect them.

CN1: 37-pin D-SUB connector / CN2: 30-pin post head connector

Cables and Accessories for 37-pin D-SUB Connector Type

*1

Opto-isolated input external interface provided through 37-pin D-SUB connector. TTL-level input provided through on-board 30-pin post header connector.

Connect to a terminal block
Connect to a discrete wire cable

Connecting with a terminal block

	Cable (37-pin)		Accessory
	0.5m PCB37PS-0.5P 1.5m PCB37PS-1.5P 3.0m PCB37PS-3P 5.0m PCB37PS-5P Shielded cable 1.5m PCB37P-1.5 Flat cable		EPD-37A EPD-37 DTP-3C DTP-4C Terminal block

	Conversion cable (37-pin)		Cable (37-pin)		Accessory
	DT/B2 Flat cable		0.5m PCB37PS-0.5P 1.5m PCB37PS-1.5P 3.0m PCB37PS-3P 5.0m PCB37PS-5P Shielded cable 1.5m PCB37P-1.5 Flat cable		EPD-37A EPD-37 DTP-3C DTP-4C Terminal block

*
When connecting a non-isolated TTL/LVTTL input/output, use a cable with a length of 1.5 m or shorter.

Accessory - 37 contact terminal block (for 37-pin D-SUB connectors)

Screw lift-up crimp relay terminal block: EPD-A series

Prevents terminal screws from falling out
Terminal screws are generally a hassle to remove when working with R-type crimp terminal cables. On the other hand, loosening them too much can cause the screws to fall out.The screw lift-up type terminal block is the solution to these problems.Even when terminal screws are loose, the inner spring lifts up and holds the screw, preventing it from falling out.

Connecting with a discrete wire cable

Connecting with a discrete wire cable

*2

Opto-isolated input provided through 37-pin D-SUB connector (CN1). TTL-level input provided through 30-pin post header connector (CN2).

	Cable (37-pin)
	0.5m PCA37PS-0.5P 1.5m PCA37PS-1.5P 3.0m PCA37PS-3P 5.0m PCA37PS-5P Shielded cable 1.5m PCA37P-1.5 3.0m PCA37P-3 Flat cable

	Conversion cable (37-pin)		Cable (37-pin)
	DT/B2 Flat cable		0.5m PCA37PS-0.5P 1.5m PCA37PS-1.5P 3.0m PCA37PS-3P 5.0m PCA37PS-5P Shielded cable 1.5m PCA37P-1.5 3.0m PCA37P-3 Flat cable

*
When connecting a non-isolated TTL/LVTTL input/output, use a cable with a length of 1.5 m or shorter.

Counter Card Connectable with a 37-pin D-SUB Connector

PCI

CNT24-4(PCI)H

Accessories compatibility